Recent content by astandupguy

how much shorter is a stock rn pole compared to sxi? definately my next mod is shorter handpole

my problem is that, my friends skis usually break, so then i work on it, and they end up riding my ski while i sit on the beach, so get friends with nice skis.

got a 750 flywheel w bad ring gear, if u got one layin around ill take 1

sure take a picture after i fall...

where do you ride at jordan? i ride el capitan

machine shop says, they used the 4 and a half thousandths gap on the wiseco box, and i believe them, so either they overbored or my rings arent siZed correctly. only way to know is to rip her apart and measure. so do i ride it one more time? or just rip her apart, either way im waiting on a...

both are 110 psi,Cylinders prof. bored by my local machine shop, matched to my pistons, but when i checked ring end gap, it was around .0018 , its supposed to be around .0010 i believe. i have heard that you dont need to set end gap on wiseco top ends, because they do it from the factory. also...

you dont really need a pisser, unless you have dual cooling , so the head would have two outlets, one to exhaust, and one to the pisser

got about half a tank through my new motor, mostly stock. I just i did a comp check and got 110 psi, how much will this increase when the rings seat? 30-40 psi im assuming

before-after

looks my skis twin! sick ski man

mine was getting real hot too. right before the bottom end let go

lol !

av gas doesnt break down like pump gas either, years rather than months

I ended up getting a big pin motor, and a new hot rod crank , top end kit , reeds, im keepin my kawi and getting a super jet. maybe this winter. big pin= better low end porting is what i thought but maybe im wrong.