D cutting Help

[JonnyB]

You don't need anything but a 4-5 in side grinder,mark a line grind it to the line and maybe finish it off with some 80 grit sandpaper,last one took me about ten minutes tops.:wiggle:

yes but when you have access to fun tools you just have to use them

 

[grahammy]

Where do ya ski? No surf in the West midlands for sure.
I'm guessin the freeride innovations logo puts you down south Devon /Dorset coast?
Do you get much surf there?

 

[z00m]

No i ski in wales barmouth, i get me stuff from freeride, i get to the coast at least once a month for 2 a day a trip

Mick

 

[six5hooSX]

I cut my 650SX ride plate one inch shorter then stock I like it.

 

[z00m]

I cut my 650SX ride plate one inch shorter then stock I like it.

what affects does it have on the ride, is that also d cut or just cut back

 

[WAB]

On my old x2, I cut the plate straight across, just behind the rear mounting bolt holes. It helped get the nose up some I think.

 

[six5hooSX]

It's cut back. It helps for terning quicker, getting the nose up, helped me out big time with stabs and subs. I run a stock 650 with foot holds, quick steer, milled stock head
168-175 and yes the 28mm carb. So I need all the help can get to make this slow SX come around.