- Location
- Clay Twp, MI
Meh was only 20 bucks total lol.. In your opinion if I'm trying to keep it cheap should I keep the oem reg and starter relay and just put new ends on everything?
Sent from my SM-N920V using Tapatalk
Sent from my SM-N920V using Tapatalk
- Location
- Stouffville, Ontario
If you can I would. If not just clean OEM and run it. I assume your running freshwater which gives us a certain amount of leniency
- Location
- Los Gatos, CA
There was another mention earlier in the thread about the OEM connectors only being crimped, so they may look ok but they can corrode inside where you can't see it.
I would try cleaning it all really well first, and you can check resistance across the connectors. It may be ok to run.
Next step would be new connectors since the OEM reg and relay are probably OK.
You can also send all your parts off to JetManiac for a rebuild, or just get connectors from him.
http://www.x-h2o.com/index.php?thre...tor-start-stop-solenoid-cdi-msd.146781/page-3
I would try cleaning it all really well first, and you can check resistance across the connectors. It may be ok to run.
Next step would be new connectors since the OEM reg and relay are probably OK.
You can also send all your parts off to JetManiac for a rebuild, or just get connectors from him.
http://www.x-h2o.com/index.php?thre...tor-start-stop-solenoid-cdi-msd.146781/page-3
- Location
- Clay Twp, MI
Awesome thanks man!
Sent from my SM-N920V using Tapatalk
Sent from my SM-N920V using Tapatalk