How do I remove a 1991 an Sj driveshaft from pump?

[kwakhead]

Hi guys. Got my ski all apart, ready to throw a Solas mag pump on, and I already got the impeller, nozzle, wear ring, and cone off. I can't get my driveshaft out if the pump stator though! Any suggestions would be great.

 

[kwakhead]

This autocorrect on these phones these days!!! I meant SN SJ at the title and it auto corrected and put "an SJ" lol sorry about that.

 

[txsuperjetfreak96]

Easy man. Remove pump cone press drive shaft out the back. Pushing on spline side. Ive done it with a hammer but b sure u put a block of wood on splines so u dont screw theme up

Sent from my SCH-I535 using Tapatalk

 

[Mdavies_02]

Due to the clearance issues with Solas Mag pumps I would recommend installing it with the Hot/Cold method or send it out somewhere/us a proper press. I installed my first set with a sledge and block of wood and the bearings went in a half season.

Just my thoughts.

 

[txsuperjetfreak96]

Due to the clearance issues with Solas Mag pumps I would recommend installing it with the Hot/Cold method or send it out somewhere/us a proper press. I installed my first set with a sledge and block of wood and the bearings went in a half season.

Just my thoughts.

Agreed

Sent from my SCH-I535 using Tapatalk

 

[Quinc]

little bit of heat and a hammer or hit the spline end against a block of wood on the ground with a little force. The shaft is going to come out of the cone end.

 

[kwakhead]

Sounds good guys thx