- Location
- Charlotte NC
OK guys, I have an old cast non p/v 7 port lamey cylinder......it needs sleeves currently at 89mm bore....would like to add some stroke to it if possible....who wants to take my money??
Custom/Hybrid engine builder
- Thread starter jo5hi3
- Start date
ProSouth
Seriously, Don't be a dick.
- Location
- kawasakis suck
I think paul Lehr has some 'speriance with those cylinders. His name is Jr. on here. Nicest guy, knows what he's doing
madness maker
John
- Location
- freaked on long island
My girls ski has same cyl (but 85mm pv) lately i thought of re sleeving and adding stroke as well. kyle at dasa said he had sleeves,and was happy to help.. maybe give him a try. they always did right by me.
awesome cyl,it hits nice even on stock stroke at 771cc.
awesome cyl,it hits nice even on stock stroke at 771cc.
- Location
- South Florida
Paul is pretty busy right now. Probably better luck elsewhere. Jetworks would do you right too.
- Location
- Charlotte NC
I was actually leaning towards tricky.....but I sent him a pm last week and I haven't heard back.....maybe he is busy or maybe he doesn't want my money....
- Location
- South Florida
Here's you some stroker cases already setup for same cylinders.
http://www.x-h2o.com/threads/141451-62t-cases-Ported-trenched-and-epoxied
http://www.x-h2o.com/threads/141451-62t-cases-Ported-trenched-and-epoxied
that guy stays busy, find someone with a phone number he has always gone about and beyond for my friends. personally ive never had the coin to just say hey tricky build me a arm ripper. others have ive ridden them and never once was i disappointed.
- Location
- Charlotte NC
That would be awesome if someone could put me in touch with him....would like to get this project started
pm sent, hope it helps you. dont give up, go tricky!
- Location
- Charlotte NC
got in contact with tricky....cylinder is going out this week...thanks again guys..
you wont be disappointed i promise
- Location
- Charlotte NC
the only way to go now...stroked.....done with ss
