Super Jet Brand new 2010 SJ

[timberg]

Just picked up a couple of 2010 skis; 2010 SJ and 2010 SXR today. Great time to buy, bad time to ride, temps dropping into the teens tonight. Since these are completely bone stock, where do I tap into the Superjets cooling system to add a flush kit, and should I just make one and if so what do I need? I see other threads that show winterizing etc.. but they all have the aftermarket pipes etc. so I'm a little confused. You would figure the dealer would have done this, but I made the mistake by telling them that I would take care of winterizing. Thanks for your help in advance!! And if this post is in the wrong section, sorry.. I'll try and do gooder next time...

 

[waterfreak]

to add a flush kit in an oem exhaust, you just need to put a t fitting where the cooling line comes from the bottom of the pipe to the rear of the cylinder head, unless their is already a place to put a flush kit next to the cooling line on the bottom of the pipe .
hope this helps!...and welcome to the X!

 

[timberg]

Thanks for the reply, I'll give that a look. Thanks

 

[timberg]

After a good nite sleep, I took another look and noticed there is a plug (flat head screw type) on the OEM manifold. Would this be where I would install a threaded nipple with a short hose with a garden hose connector and a plug so I can leave it in the boat? Since the ski is new, I don't need to flush, just what to gravity feed some RV antifreeze through it. I know this subject has been hit many times in this forum and maybe I'm asking the wrong questions in the search box... I'm learning. Thanks

 

[waterfreak]

After a good nite sleep, I took another look and noticed there is a plug (flat head screw type) on the OEM manifold. Would this be where I would install a threaded nipple with a short hose with a garden hose connector and a plug so I can leave it in the boat? Since the ski is new, I don't need to flush, just what to gravity feed some RV antifreeze through it. I know this subject has been hit many times in this forum and maybe I'm asking the wrong questions in the search box... I'm learning. Thanks

yes ,that's the one! just install a threaded nipple and put a standard flush kit
I'm guessing that you store your jet ski in sub freezing area.