Latest activity
-
WFO Speedracer replied to the thread DIY Port Jobs.This is the porting I am running on the motor in my 300SX build , it runs really well with a Coffman pipe , I ported and polished... -
-
I don't know about where you live but here we do a lot of shopping at this place , to the tune of around $160.00 per week usually , we...
-
WFO Speedracer replied to the thread DIY Port Jobs.I would have liked to see those transfer port bridges knife edged though .It's something I always do on port jobs I have done .
-
WFO Speedracer replied to the thread Flipping couches for fun and profit.I have to admit I worked on a few of those and rode them and they were quite impressive, I remember riding a Genesis and a FX140 back to...
-
RRonald Poitras replied to the thread Dasa 900.Bump.
-
loictahiti reacted to waxhead's post in the thread Stop blending your manifold. your killing your low end power and throttle response with
Like.
the problem being now to make it cast it very expensive to make the mould and lets be honest im not going to sell that many of them... -
kevbo replied to the thread Stop blending your manifold. your killing your low end power and throttle response.Reducing the area between the reed and butterfly will increase the pressure drop at the Venturi. It should make jetting a tiny bit... -
orangefinger replied to the thread Flipping couches for fun and profit.oh no .... what have i done ... -
-
WI know about some of this stuff from using a lot of these fillers over the years but even I found this video fairly interesting and...
-
jeremy55001 reacted to Quinc's post in the thread 650/X-2 Salt Water into engine when not running with Like.
Make sure you have a good hood seal and make any adjustments needed to get the hood extra tight on that seal. You can also run... -
johnmarchetta34 replied to the thread DIY Port Jobs.Fantastic work! -
1211 to seal what would otherwise be a place water could collect. Attention to detail!
-
Baja 252 replied to the thread DIY Port Jobs.You asked to see some pics, so here are a few pics of our 08 701 SJ cylinder porting. The case porting is just a photo I found... -
-
johnmarchetta34 replied to the thread DIY Port Jobs.Can anyone tell me what this white stuff is around the head studs when using a girdled head? I assume i need to replace it.
-
-
TOBY replied to the thread New BLACK FRIDAY $100 Chin Pad sale.Shipped 3 today Still have 3
