650/X-2 What Part/Part#/Size is this?

[KawiKid]

Hey guys,
disclaimer..this isn't my ski, but im posting from work and hoping to stop somewhere on way home to pick one up...Does anyone know the EXACT size of this hose clamp? like if I walked into the hardware store, what should I grab/ask for? I Don't want one that "could" or "would" work, where id have to cut the tail off and have sharp edges.. just looking for the stock/noemal size.. I need just one..(the left side) but I figured these are both the same.
Thanks!

 

[hondamatt450]

hopefully this is a joke take the coupling off and measure the OD. i believe that is a 4" hose clamp if you can't figure that out you probably shouldnt be working on a ski or any motor for that matter

 

[KawiKid]

@hondamatt450 no, wasn't a joke in the least, just a serious, practical question. if you read the first line of the post, you'd understand why I asked. I was tightening the clamp the night before around 1am and thought I heard an unusual noise. called it a night and then left for work in the AM. while I was at work, I decided I wanted to stop on the way home and get a clamp to avoid going back home, getting the clamp off, then sitting in about 2 hours of traffic, meanwhile I have a hardware store 1.7 miles away from my job. I simply wanted to stop on the way home. Well, I picked up two on the way home after someone responded to me. sure enough, I took the one clamp off, it did have a crack and a tiny piece of rust, so I replaced both and now its good to go.