300/440/550 Westcoast X-2 Pipe Water Lines

[BlueBreadTruck]

hey guys, I just got a used westcoast pipe for my x-2. i was just wondering if anyone could give me some detailed info or pics of how i should set up my waterlines! Im not even sure my ski is set up correctly right now.

Thanks!

 

[Powder]

not sure if they are the same but maybe this thread will help?
http://www.x-h2o.com/threads/10514

 

[BlueBreadTruck]

That helped alot....has that setup worked well for you? Why do you eliminate the factory rear drain? Must i get 2 pissers? or will that little stocker do it?

 

[professor961]

That helped alot....has that setup worked well for you? Why do you eliminate the factory rear drain? Must i get 2 pissers? or will that little stocker do it?

The factory water drain is normally used for the second cooling line.

Coming off your cylinder head - have one go straight out of the hull, then the other go to the pipe. On the water line that goes from the pipe to the stinger, if you want to cut that line and make a second pee line, then do that.

 

[Powder]

has that setup worked well for you?

He just rode it for a week straight and was very happy with the setup, motor temp was good pipe wasn't too wet.

 

[BlueBreadTruck]

ok, thanks so much guys. Up here the water dosent't get terribly warm....do you think i will be able to get away with single cooling with my mods? I will be putting in a new impeller so i could convert if needed, but if i can get away with the single cooling/single pisser i think it would really simplify everything