Waveblaster cutting out just on take off after sitting.

[Burpleblaster]

My Blaster runs great everywhere except when you stop riding and take a break for a few minutes and restart it. When its restarted it cuts out 1 or 2 times when trying to take off,but it starts right back up. Once you restart it once or twice it takes off and goes great.There is no bog or running issue,it just takes 1 or 2 tries to get it ripping. Any thoughts?

 

[tshank123]

Just throwing this out there. Maybe its not holding pressure. Pull the return line from the carbs off and blow into it while holding the pressure with your thumb on the carb outlet. It should hold, if not, find where its leaking.

 

[ger87410]

Maybe the gas tank is sucking the gas back into the tank. aka bad one-way valve.

 

[Dustin Mustangs]

Old needle and seat that are leaking.

 

[uga86]

Did you find the issue? My 04 superjet does the exact same thing.

Rips great bottom to top - but falls on its face/dies immediately after some warm-ish restarts.

Always starts right back up and after a few secs its clean again.

 

[SeaBeeYamaha]

Try a New fuel filter