using a shark fab, looking at ADA instructions
they show 18 for head bolts, 23 for the girdle
OEM is 11 then 22 on the headbolts and 17 then 29 on the cylinder
is AWA being conservative?
why do some people say they torque the girdle bolts to 35?
It doesnt make any sense to tighten the girdle
tighter than the cylinders, does it? :scratchchin:
they show 18 for head bolts, 23 for the girdle
OEM is 11 then 22 on the headbolts and 17 then 29 on the cylinder
is AWA being conservative?
why do some people say they torque the girdle bolts to 35?
It doesnt make any sense to tighten the girdle
tighter than the cylinders, does it? :scratchchin: