SquareNose parts variances???

[Patrick Star]

I have 2 '93 SuperJet hulls, they were mostly stock when I got them. Well one ski has a backing plate the size of the pole bracket holding on the pole bracket, the other one just has 2 very small pieces of metal with 2 holes/nuts on them holding the bracket on. I really do not see the people I got the ski from doing something like this. It's not really important, it's just stuck in the back of my mind.

One other thing, I have read about the SquareNose having only 4 bolts to hold the ride plate on, but I remember my Groovy plate being held on by 6 bolts.

 

[chriselmore_1]

Sn has 6 bolts on ride plate. Bob thats not the stock backing plate

 

[kevbo]

SN Superjets were so poorly built that you are lucky if all the hardware is even there.

 

[Patrick Star]

SN Superjets were so poorly built that you are lucky if all the hardware is even there.

I know, when I got the one in my avatar the engine, tank, and alot of the electronics were missing... J/k, I might build a RN one of these years. Not a lot of them in south, south Texas. Why pay more in gas to go pick up than the hull your getting costs.

 

[smoofers]

SN Superjets were so poorly built that you are lucky if all the hardware is even there.

:bsflag:

 

[kevbo]

I should have said only the S/N hulls were poorly made.

 

[5810]

:bsflag:

x2

 

[freakinjb]

Can you put a 4-bolt ride plate on a '90-'93 hull and just cover up the 2 additional holes?

 

[heebs12]

I dont see why not. ^^^ The other 4 holes will line up.

 

[orangefinger]

make sure to check the lenght of your hoods, some hoods are shorter and will not seal properly if not matched with the hull they came with....