DylanS
Gorilla Smasher
- Location
- Lebanon Pa
Putting my gp1100 motor up for sale as I’m moving to a gp1200 for my b1.
Motor is 1mm over bore with about 5 hours tops on weisco pistons
Compression from front to back is 140,130,140
Center cylinder had a over heating incident
Hot rods crank with roughly 15 hours on it since being sent to be rebuilt
Riva reed spacer plate, riva risers, cleaners, oil inj block off plate
I can’t remember if the cylinders were ported
Overall pretty clean, never seen salt water and will send more pics upon requ
Everything here except negative cable and coupler.
No issues besides center cylinder being down 10lbs
Carbs mains jetted 120,120,125 (front to back) and I would recommend going over them and adjusting per your application
900 plus shipping or local pickup in PA
Motor is 1mm over bore with about 5 hours tops on weisco pistons
Compression from front to back is 140,130,140
Center cylinder had a over heating incident
Hot rods crank with roughly 15 hours on it since being sent to be rebuilt
Riva reed spacer plate, riva risers, cleaners, oil inj block off plate
I can’t remember if the cylinders were ported
Overall pretty clean, never seen salt water and will send more pics upon requ
Everything here except negative cable and coupler.
No issues besides center cylinder being down 10lbs
Carbs mains jetted 120,120,125 (front to back) and I would recommend going over them and adjusting per your application
900 plus shipping or local pickup in PA
Last edited: