- Location
- Long Beach CA
Does anyone know how to do the quick steer mod on the blaster?
Blaster Quick Steer Mod?
- Thread starter offroadenemy
- Start date
- Location
- Long Beach CA
Thanks yo!!! Finish the blaster so we can go out!!!
bored&stroked
Urban redneck
- Location
- AZ
I know, I'm digging deep on this one. But I'm curious, anyone know what this mod was?
I believe you want to extend where the steering cable attaches to the steering by bolting on a extra piece of metal (stainless or aluminum) and then drill a hole closer in on the nozzle. The nozzle will have to be trimmed because at full turn it will now hit. Or you could find a pro-tec extended nozzle. I made a 3D printed nozzle extension. I stayed with 20mm because If you go too long you can bend the stock steering cable and you will need to move up to the B2 steering cable. I'm sure my extended nozzle is not as agressive as the mod.
www.thingiverse.com
Surfriding - quick steer mod question
Been trying to get some info on this mod. For a RN, do I just move the bolt to the outer setting on turn plate? Also for the nozzle, do I just drill a hole to the left of where the steering bolt is now? Trying to get an idea of exactly where it goes. Any trimming on nozzle needed? What size...
www.x-h2o.com
Waveblaster steering nozzle extension by MarkB3D
This is a steering nozzle extension I made for my waveblaster. I have been testing it this summer to make sure it will hold up and so far so good. It adds about 20mm to the nozzle for quicker steering. My concerns were, would the extension hold up and would the nozzle and steering cable take the...
www.thingiverse.com