Need some measurments off of a SuperJet

[Project Ski]

I need to know the exact diameter or the bolt/rod that the handlepole pivots on.

I need to know how wide the handlepole is where is attaches to the pivot bracket

I need to know how far it is from the center of the handlepole pivot hole to the start of the hood. I included a picture with some red lines drawn to clarify what i mean by this.

Thanks in advance for anyone willing to take some measurements for me. I am about an hour away from my ski right now and i need to fabricate some parts.

 

[Mouthfulloflake]

man... I have posted those measurments before...

I cant remember for who and what thread.
it was a guy here ( or there) that made a bracket on a cnc mill, and prototyped it out of white plastic.

 

[Project Ski]

think man ... think any idea how long ago it was or a clue what the thread title was? that will help narrow my search

 

[Project Ski]

THis is for a squarenose SJ. I did not specify that in the original post

 

[Mouthfulloflake]

ok, just give me a sec, Ill go and measure.

I need an excuse to go to the beer fridge in the garage anyway.

:biggthumpup:

 

[Mouthfulloflake]

I found it.

http://www.pwctoday.com/showthread.php?t=62709&highlight=bracket

now IM going to get a beer anyway.

haha

 

[Moondance]

now IM going to get a beer anyway.

haha

Bring me one, sweetie:beerchug: ..and thank you

 

[Project Ski]

i hop eyou didnt hit the fridge yet. I checked tht thread out, you must have PM'd him or emailed him with the measurements because there is nothign in teh thread.

Also i need the distance from the center of the bolt hole to the beginning of the hood.

Thanks
Dan

 

[Mouthfulloflake]

Bring me one, sweetie:beerchug: ..and thank you

I would be happy to bring you one.

Or seven.

:biggrin:

 

[Mouthfulloflake]

dangit..

shoes back on, must find a flashlight, boat with square pole is out on trailer, boat in garage has Round nose pole on it.

Un minuto, por favor.

 

[Mouthfulloflake]

its dark, and using a tape measure.

so...

approx 7 3/8 is the pole width ( not counting bushings)
this measurement was in teh other thread.

1 7/8 - 2" from the center of pivot bolt to where the hood starts.
that is linear, not following the contour of the hood.

 

[WAB]

6 minutes...not bad. :beerchug:

 

[accbr]

The stock bolt is 14mm. I just changed to the 2 bolt setup with no spring and was able to use 9/16 bolts which is roughly 15mm. My bushings must be worn out a little.

 

[Project Ski]

wow, you guys are quick. Thanks mouthfulloflake, sorry to make you go outside.

Now to get working on these parts.

 

[Mouthfulloflake]

no need to thank me, just make me a bracket too.

im too lazy to finish mine.