Custom/Hybrid need jetting for Buckshots
- Thread starter iptamenos
- Start date
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
There is no correct set of specs out there. Look in the FAQ section and find some carbs close in size along with mods that match closely to your setup.
Good Luck, had some Bucks, not easy to tune in, they are more of a race carb than a freestyle carb.
Good Luck, had some Bucks, not easy to tune in, they are more of a race carb than a freestyle carb.
- Location
- South Africa
I think on my old WB1 with dual 46 Buckshots I was 130P 120M 19PSI
Octane_114
LeT tHe gOOd tImEs RoLL
- Location
- Charleston S.C.
I'M in the same boat... mine are on a kaw 750 its a single 46, duel's are on a 820. before its over i'll own every jet out there..
Last edited:
Octane_114
LeT tHe gOOd tImEs RoLL
- Location
- Charleston S.C.
Technical line 714-773-4321 they will get ya fixed up
Octane_114
LeT tHe gOOd tImEs RoLL
- Location
- Charleston S.C.
these carbs will push your skills... they just take fine tuning my 750 is set runs great.
Mark44
Katie's Boss
- Location
- 100% one place
Sounds like you need to tune with a tachometer. Check the tech section "tuning for rookies" thread by Randy at Watcon.
Mark44
Octane_114
LeT tHe gOOd tImEs RoLL
- Location
- Charleston S.C.
i'm using a tach, i didnt know anything about the reverse jetting on the buckshots and bought a few sets to start off with, i just spent a lot of loot on the big bore 820 and dont want it to go up in smoke