Kawi1100

[motoman3000]

Took out the new 1100 blaster today w/ the dry pipe mod I did. The 1/2 " pisser from the bottom chamber was blazing hot but pissin good as were the 2 3/8 pissers, which were warm. Normal ? Thing is my 1/2 " outlet is goin right into my footwell. Hot!!


Sent from my iPhone using Tapatalk

 

[Jetfiend]

My 1/2" on my B1100 runs luke warm.

 

[motoman3000]

Hmm I tapped my pump for 3/8 and have a 3/8 by 1/2 thru hull fitting. Wonder if it makes a difference. Really don't wanna pull engine to check that fitting pita


Sent from my iPhone using Tapatalk

 

[Jetfiend]

I'm running 3/8 and 1/2 from pump, might have something to do with it. How's it running? I could tell an immediate improvement after drying out the pipe.

 

[motoman3000]

I'm running 3/8 and 1/2 from pump, might have something to do with it. How's it running? I could tell an immediate improvement after drying out the pipe.

I as well , but comparisons will be difficult as it's my 1st time on any blaster. It sounds awesome , pulls hard so far. Still breaking in the engine on 1st tank - had chuck @ CPT go thru it and do some stuff. I'm being overly cautious


Sent from my iPhone using Tapatalk

 

[Jetfiend]

Ride it and have fun, they are addicting.

 

[clubfx2]

What GPS reading's you guys getting on these? Mine is nearly ready for water testing and will be a flatwater race boat. Haven't seen much feedback from fellow modders with similar setups.

Cheers

Clyde