After opening up my Xjet, I found all of the inserts are either cheap stainless or mild steel. I was wondering if there was a hull builder out there that would sell me four ride plate and four pump inserts to save me the hassle of trying to make some? Ones that match OEM SJ thread size and pitch is preferred.
Hull builder willing to sell inserts?
- Thread starter yamanube
- Start date
- Location
- New York Crew
fyi you can buy from yamaha for the ride plates, not sure on the pump but i would assume
- Location
- Stouffville, Ontario
I'd grab a set as well. Let me know if you have any luck
- Location
- South Florida
Just switch to standard thread stainless t nuts. So much easier and cheaper. Always use antiseize though.
Vumad
Super Hero, with a cape!
- Location
- St. Pete, FL
- Location
- New York Crew
Check a different year SJ
90179-08962-00
90179-08962-00
cookn
Kamikaze
- Location
- where you live
I was going to make some for my x jet. I have the equipment but am in Canada. Ill keep an eye out here and see where it goes. I can always put them in the mail
Ducky
Back in the game!
- Location
- Charlotte, NC
I have these if itll help you...you can have them for free. Youll need to make one more as I only have 7. They are currently drilled and tapped for an M6, but could easily be drilled out and re-tapped. I could probably take care of that for you as well if necessary. They are like 1 inch by 1 inch.
Vumad
Super Hero, with a cape!
- Location
- St. Pete, FL
I used stainless barb tee nuts in my x2, but metric is very hard tp find. I think they can be had in brass too. Mcmastercarr i think