I just installed a new factory pipe and I am trying to get my ski tuned, I pulled the carbs off the ski to put in the recommended main jet and set the high and low speed screws to the factory pipe settings as well, know that its together how the heck do you get to the high speed screw on the forward carb to make adjustments. The low speed has the little knob on it to do with your finger but the high speed doesnt. Just wondering how every one gets to the high speed screws.
How to get to carb screws
- Thread starter Lucas
- Start date
wayne
wannaroll
- Location
- Mesquite, Texas
you have to drill the plug out and then you can adjust them. i would get the jetworks t handles for the carbs to make it easier to tune.
jetsport484
Are we there yet?
- Location
- Lake Hartwell, SC
Its A PITA! but I use a small skinny flat screwdiriver about 6'' long and it has a curve in it that helps a little as well. I also try to collapse the exhaust tube as much as possible. like I said its a PITA but I've actually gotten pretty quick at it. The screws wayne mentioned are the shizz, but I'm too cheap to invest...Patience goes a long way.