the hood i have was modified by one of the old blowsion guys w/ 2 rear air intakes that are about 2.5 niches each in diameter. they are in the same location as they are on the round nose hood. i already glassed over the very front air intakes that are underneath the hood hooks, but was wondering if anyone has also glassed over the ones that are on the top of the hood (underneath where the handle pole rests) Do you guys think the 2 holes at the back of the hood will be enough for the motor to breath?
FX-1 glassing over the stock air intakes?
- Thread starter Bern
- Start date
- Location
- Minneapolis, MN
I would guess that would work. If you feel like the motor is not getting enough air you can always widen the rear holes
- Location
- Little Rock Arkansas
I just put tape over the front four air holes and opened up the rear two to about 2.5". Ran it like that for 15 years. You should be fine.