cutting stock exhaust hose for bpipe

[Gainera2582]

Note: I am not spending 45 bucks for a silicone elbow, so thats out of the question.

I know the stock exhaust hose on the rn is a bit bigger than the end of the stinger. Should I just take my pipe up to the autoparts store and get a radiator hose that will fit over the stinger so I can fit it to the cut down stock elbow?

Thanks,




Aaron

 

[beachedflunkey]

Cut the hose and tighten that clamp.

 

[Waste Land]

Get a heavy duty clamp...two is best

 

[Gainera2582]

So you guys are saying I don't need the radiator hose to fit over the stinger, just clamp it with two heavy duty clamps?

 

[beachedflunkey]

I clamp it with the one that came stock but go for the two heavy duty ones if that'd give you better peace of mind. It'll fit fine.

 

[romack991]

i just use two regular hose clamps, never had issues.

 

[wildman326]

I use 2 also, right next to each other, tighten one, then the other, then the other, etc until they are solid.

 

[robertg]

I would try to get one at an auto parts store. You never know when you are going to need your stock hose.

 

[wildman326]

For what? Just curious.

 

[robertg]

A TNT or blaster mod chamber uses the stock hose.

 

[wildman326]

Right you are. Touche.