does anyone have the skills or know someone who can do some easy aluminum fab for me? i want a peice of billet to go on my dash where the hood latch, fuel selector is...maybe 1/8" thick with rectangular dimensions. paypal is locked and loaded.
anyone do aluminum fab?
- Thread starter Pablo
- Start date
stanton
High on jetskis.
- Location
- atascadero,ca
show me a print.
what u willing to pay?
u will want/need to get it anodized.
what u willing to pay?
u will want/need to get it anodized.
stanton
High on jetskis.
- Location
- atascadero,ca
so all u want is a plate?
i thought you were gonna want something a little more complex than that.
go to your hardware store and check out their selection. should be some material you can use. use a jigsaw and cut it to size file or sand down the edges. done.
i thought you were gonna want something a little more complex than that.
go to your hardware store and check out their selection. should be some material you can use. use a jigsaw and cut it to size file or sand down the edges. done.
nahhh pretty simple... i didn't turf that area and wished i had now. wanted to neaten it up a bit from stock. i spilled some acetone on the black and made it run and look sh_tty. if u want complex then machine me a new set of big bore jugs with a nice port job....lol. u take payments?
demolition_x
Not After Fame & Fortune
- Location
- Holden Beach / Wilmington NC
check out this guy on ebay. he sells tons of aluminum.
http://stores.ebay.com/8020-Inc-Gar..._W0QQcolZ4QQdirZ1QQfsubZ6482363QQftidZ2QQtZkm
http://stores.ebay.com/8020-Inc-Gar..._W0QQcolZ4QQdirZ1QQfsubZ6482363QQftidZ2QQtZkm
#ZERO
Beach Bum
- Location
- Florida - U.S.A.
Why do you want to make it out of heavy aluminum that might corrode?
Textured plastic would look just as nice and would be easier to fabricate.
Textured plastic would look just as nice and would be easier to fabricate.