Acusteer replacement bearing number?

Crab

Crab

thanks darin...noswad!
Location
Seattle
Anyone happen to know what bearing goes in the Acusteer, mine are wasted and I really would like to upgrade to SS sealed bearings if possible.:thewave:
 
michael950

michael950

for me to POOP on!
Location
Houston, TX
I have the numbers for the Blaster steering system in the TechFAQ, in the reference library.

Not sure if they are the same, but might be worth a look.
 
Crab

Crab

thanks darin...noswad!
Location
Seattle
michael950

michael950

for me to POOP on!
Location
Houston, TX
It's not easy, especially if you have rusted bearings.

I knew this to be a problem and bought stainless cased bearings before I installed mine on the blaster.

I do recall I did not use a press, it was all done by hand.
 
michael950

michael950

for me to POOP on!
Location
Houston, TX
Since the old bearings are trashed, I would protect the steering and use a hammer and chisel (or screwdriver) to knock out the old bearings (since they are garbage).

I would start by removing the center/steering shaft.
 
shawn_NJ

shawn_NJ

Chasing waves.
Location
Daytona Beach
michael950 said:
Since the old bearings are trashed, I would protect the steering and use a hammer and chisel (or screwdriver) to knock out the old bearings (since they are garbage).

I would start by removing the center/steering shaft.
Click to expand...

Thats what I did with my UMI. I also LIGHTLY torched the housing to help relieve some of the tension holding the bearings in. When reinstalling, throw the bearings in the freezer (prepacked in gease) for a few hours, and then throw the housing in the oven at a low heat for some time. This way the bearings slide right in, and when the housing cools they're not going anywhere. Then pack EVERYTHING in marine grease.
 
Last edited:
Crab

Crab

thanks darin...noswad!
Location
Seattle
Follow up, I got in toutch with an Ebay vendor I have bought bearings from before, he will have some in a couple days. The premium stainless R12-2rs is $9.95 each, when I get all the contact info. I wil pass it on.
 
Crab

Crab

thanks darin...noswad!
Location
Seattle
Please guy's wait until I get mine and check the fit on them, I will let you know ASAP. Jeff



HILL INDUSTRIAL SUPPLY, INC.
This email confirms that you sent a payment for $24.85 USD to bobhill5@earthlink.net.



----------------------------------------------------------------
Payment Details
----------------------------------------------------------------

Amount: $24.85 USD
Subject: (2) SSR12-2RS PREMIUM bearings
Note:Here is your invoice for (2) SSR12-2RS PREMIUM bearings, including shipping and handling. Thanks, Bob
Click to expand...
 
Crab

Crab

thanks darin...noswad!
Location
Seattle
Follow up: I just installed the bearings, perfect fit. The only thing I noticed was they must have some iron in the alloy, as they are magnetic. For $25 bucks, if they last a season or 2 I figure thats better than the junk that was in there. I also drilled a small weep hole just above the lower bearing at the rear to facilitate water drainage if it should get in there.

Ultra-Hard Wear-Resistant Stainless Steel (Type 440C)

When heat treated, one of the hardest stainless steels. High carbon content provides good wear resistance. Magnetic. Ideal for bearings, valve parts, and knife blades. Temperature range not rated.
Click to expand...
 
Last edited:
You must log in or register to reply here.
Top Bottom