revolver

engine in good condition just changed all the gaskets and seals two months ago 5 hours since the re-freshed checked all over run fine and rep Piston : 90.5 mm Crank : 10 mm Carbs : full spectrum 49mm Asking 4700$ obo ( can ship worldwide in buyer expenses) can throw a thrust 155 pump with the...

The hull is in a very good and clean condition had it for two months only the hull will come with the atp poles and a thrust 155 pump asking 9500$ obo ( can ship worldwide in buyer expense ) located in doha , Qatar ready for ship and setup more details and info in PM

its been a long hard decision but i think its time to thin the heard for now. i just don't have time to rid one ski let alone two and get it set up. i was trying to build a Lee stone replica but lack of use this year and no time to tune it properly with short ride seasons on this glacier fed...

revolver 2020 v1 full carbon not exposed C3 xscream engine 1200 (engine been bought of a friend with low hour’s on it ) 163mm xscream pump Msd totel loss Xscream carb 52 mm Xscream trim system Atp pole and turn Everything on the ski is new and bills are in hand Ski like new build it on covid...

Here a few pics of a Hydro-Turf job I just did on a friends ski, first time using different colours for me but turned out pretty sweet I think......

Going to pick up my LSP Pro Series next week so thought I’d start a build thread. Aiming to get this built ready to ride just after new year, working away and no time at home will slow the progress but most parts are ready to go. All the setup from my previous Revolver R will be going in, all...