Search results

When I did the carbs I used the same springs should I get new springs? How do I know what springs to get? I put a restrictor inline on the return didn't make any difference

I am thinking about trying a new cdi box I also have new reeds coming in a few days so I will put them in as well

Stock pipe and changed coil I think that helped some but still does it I did a river ride on the weekend running 3/4 throttle to wide open for two tanks of fuel and it only did it a few times it's only when you let off and grab a handful of throttle more so when coming out of a spin and nose...

I have the coil on the way if that doesn't do it I will find a cdi box I am pretty confident it's not the carbs

It was all genuine parts in carb and it didn't make a single bit of difference

And thanks guys it's much appreciated

Yes aftermarket arrestors stock jetting and popoff but it started doing this before I put them on I added them when I did carb rebuild

I will try coil I just ordered one and I have the cdi box off my blaster 1 are they the same? it's good I know because I took it off to put a msd box on it

So hear is what's going on it's a 96 Waveblaster 2 it runs like top but when you have been running wide open then get off the gas and back on it falls on its face if you don't let off the gas it will die but if you feather it stays running and takes right back off I completely went through both...

Where are you located are they still available?

Where are you located?

Looking for another Waveblaster I I am in washington willing to drive a good distance to pick up

Thank you much

I know that but other people on hear told me I need a gasket as well which makes no sense

So I talked to protec today to order o rings they said no gasket with the protec head just o ring and a thin layer of permatex can anyone confirm this?

What are you wanting for it?

Are the threads good in the pipe mount I have a protec pipe so it would use them two holes how much you asking?

Ok thank you

Looking for a protec head for Waveblaster 1 and a pipe for a Waveblaster 2 if anyone can help me out

Just installed a protec pipe on Waveblaster 1 tested today runs way better my question is starting point for the two flow controls for the water flow