Search results

He won't reply to anything

I'm serious, I'd send some money right now if the guy would check his email

Better than anyone else has offered from what I've seen.

$1200 bare hull shipped?

block one side of the head pipe and use compressed air in other side and make sure air come out in the inside

have you rode it? if it hits the limiter that quick chances are too lean.whats the temp there?

b pipe will fit but not with factory tank. i have a sxi limited pipe I cut and turned the end on. but then you start running into waterbox problems and battery mount locations. Its all custom fab when you put the yami motor in.I run a 300sx tank melted just a little.Thats with a 750 kawi and...

701 you will not be disappointed......

what is the best way to be able to put a 62t bottom in this?

Or somebody put oil in it because they didn't know any better

I cut all bumps off and smoothed the whole front. Wondering if anyone can give me an idea for fiberglass footholds in the rear. Any help is greatly appreciated

do not rocker or cut the trim off of the nose, you will have to wear goggles because it splashes so much water up in your face. The bond line in the front is also a splash guard. as far as cutting the back goes, cut it right behind the rear pump bolts and shorten the pole to match your height...

ditch that 650 and just buy a 750 if you are willing to spend several hundos on that. it will bolt right in with no mods other than a pipe.

Ground the rail off the front last night, still have alittle more shaping but it's close. Does anybody have experience with a pancake Pete front foothold? If so is it worth it or not?

sweet! Thanks for the info.

I road a chan a couple of times and that is the hardest ski to get up on because the gunwales are only like 2 inches tall. I think It's easier to graft a whole cavity in than to put the 650 pump in the 300 cavity.

Just widened it out right here

The tray should be about 20" wide once glassed and turfed

Trimmed it out just like the 650 cavity is cut, to where the ears on the front of the pump are inset into the cavity I'll try to take some pics when I flip it over tomorrow. Got some more cutting done when I got home today. I really like the way it's starting to look! Still have a lot of...

Cutting the gunwales out tonight. What is you guys view on straps vs holds in this build?