Search results

this was on factorypipe website http://web.archive.org/web/20040411053539/www.factorypipe.com/800SX01/time800SXR.html

I use atlantic jetsport alot for orders to europe , Jim is a top guy and has always looked after me and replied to my emails (usually within a couple of minutes) i have used vendors from other forms of motorsports and AJS are close to the top of my list regards Neil

thats how i run my h2o solenoid wires out through the the rubber grommet where the ambient sensor and over heat come out

i believe the cdi takes its power from the back of the starter relay post (the one the main positive lead off the battery goes too) and through a 10 amp fuse under the fuse cover either remove fuse or fit a waterproof switch on this red wire pm me if you need wiring diagram regards Neil

What ignition are you running ? mine doesnt drain the battery its one of waxheads inferno ignition, works excellent easy to change curve and ecwi no seperate on switch needed and good battery life on total loss. hot products do some quick release battery connecors pt. no. 59-0527...

might be worth checking pulse line fom crankcases to fuel pump,i know SXR have an issue that the carb rubs on the pulse line and wears a hole through it regards Neil

Lurking:arms:

ok i found it on http://www.archive.org

[/URL][/IMG] [/URL][/IMG] its a lot harder to write how to do it than actually doing it , i zero the gauge by pushing the piston tight onto the squish area ,when you zero it as long as you use either the piston you are going to run or an identdical dummy the raised area ontop of the piston...

Hi guys i have been reading posts on squish gaps and see you all seem to use soft core solder, i do it a different way which IMO is more accurate. you will need a reasonable quality dial gauge and extension and spark plug adaptor (i find a digital is easiest to use ) it is also easier if you...

Hi guys im thinking of swapping to amsoil on my limited SXR and i am not sure if i should go for interceptor or dominator i ride in the sea freeride and fast rec my mods are TBM limited dome kit 185psi 60 thou gasket TBM girdled head kit factory wet pipe TBM total loss flywheel Novi...

i heard that they are made to order ?

Is it possible the crowns onthe top of the pistons may be mis machined or just the wrong type, some of our rotax kart pistons come in different versions flat top or crowned ? regards Neil

i have just tapped mine in the boss next to the steering cable ,it is tight but possible, i shaved a bit off the boss and tapped it so the fitting went to the end of its threads and cut the excess inside the pump off. i angled the fitting up at 45 degreesso it goes above exit nozzle to the...

optimate3 comes with waterproof plug to mount on ski ,maintains,tests and desulphates http://www.optimate3.com/classic/

same part no as sxi pro , probably used on others