Search results

PM sent

Was curious if there was anyone riding around Table rock state marina or surrounding area ? Thanks !

Just needing to know which direction the small crank seal (on flywheel end) faces ? It has open face with the spring on both sides with only difference being small offset. Thanks for any help.

Thats a heck of a thread..very helpful. Thanks again.

Thanks brotha... Im on it.

Well i know its not stock.. it says factory b pipe. Does that help ?

Can anyone tell me a good post about rounting cooling lines... I would like to have a better idea of exactly how the plumbing works. Im not sure what dual cooling is either. Thanks.

ok will do. Thanks man.

Im getting ready to tear into it soon. Im guessing its at the exhaust manifold gasket. I noticed a little salt build up there on the outside so if its on the outside i would assume the gaskets not holding. As far as leak testing i didnt do. I have been in motocross all my life and have...

ada head from wamiltons

I just rebuilt the engine and noticed it would bog down on top end.. wasn't sure why until I pulled the plugs and seen water in there. Where could this be coming from ?? Any help would be greatly appreciated. Darren.

Thanks man...just makin sure before the purchase.:scratchchin:

Ok thanks. So 96 and up are all the same right ?

I have an 08 Superjet. Just wondering if the flywheel and stator assembly are all the same on 96 up to 2012 ? Thanks.

Ok guys found it.. it was the MSD enhancer... took a stock one out of my wifes blaster and runs fine... well besides the fact the rev limiter wont let it run past fast idle...lol. Seriously you dont realize how much difference the MSD makes until you put a stock one on. I rode today for 3...

Just installed new crank and pistons...first few times it fired up and ran just fine... shut it off and tried again.. it acted like it wasnt firing until i let off the start button. Then boooom... it back fired like a frickin shot gun. Let it sit a while longer then started agian... runs like...

Just curious if a Riva 1 is ok for flat water freestyle. Thats what Wamilton recommended so I am installing one today. How much different is this than the worx 201 ? Have a modified motor..not big bore. Thanks for any ideas.

Yeppers Dag..... that sounds like what could've happened. This is the second time out this year.. so if I were guessing I bet I had water in it when it was stored this winter ..im not sure how. I guess ill be given the ole yamaha a shot of oil before storing next year. Well im calling...

Ok.. found it. One of the two middle bearings started coming apart. When something like this happens... first thing I want to do is figure out how and why it happened.. was it something I did or just one of those things. First thing comes to mind is did i have enough oil. And yes I did. I...

clips were both intact. From looking at the top of piston.. it was pretty large piece of metal.... at least the impressions it left in top of piston.