Search results

Man for B1 mod pipe - waveblaster 1

Man for B1-Mod pipe - SuperJet

Is the cable from a SJ stator (62t) long enough for use in the blaster?

Set a Guinness World Record Enjoy a Better Web Sounds like a good deal, right? All you have to do is get Firefox 3 during Download Day to help set the record for most software downloads in 24 hours - it’s that easy. We're not asking you to swallow a sword or to balance 30 spoons on your face...

At what point do you add fuel line restrictors, and how do you determine the correct fuel (flow) requirement? This is for my recreation setup, but it's a LPW sport port with dual (retail) 44s. I hope to do some tuning this weekend, but I started thinking about this as the last thing I need to...

Is the aluminum cone for the blaster only, or do you use the rubber on the blaster as well?

I know everyone shoots for a boat with the 701, but what benefits are there when upgrading from a 650 to 61x 701? Is there a benefit for the added cost to upgrade?

What material can the fuel tee be made of? The plastic tees on McMaster only indicate air and water. Acetal | Nylon | Polycarbonate | Polyethylene | Polypropylene | PVDF (Kynar)

I know there are some modifications that should be made to the Octane out of the box, some due to design flaws. Here are a list of modifications that you might want to look into. (I have no clue, but sure Randy @ Watcon (who is dealing with World Finals) and Prem1x could chime in).

Anyone going to bring any goodies they plan on selling?

Anyone know where to buy the hose in bulk, or hose of similar softness (Durometer rating)?

I recall reading a thread ages ago about someone using cable ties instead of hose clamps and have a problem doing so. What's the consensus on using cable ties instead of hose clamps.

I am looking for a copy of the Yamaha square nose service manual... 90-93 &/or 94-95. I have a copy of the Round, and specifically looking for a square.

What is the length of a square nose per Yamaha.

Who's driving to Daytona, and how yous gettin' there?

How do you clean/remove the old HT/Dap Weldwood glue?

When do you use one or the other? I'm reassembling a short block and installing the manifolds, flywheel cover, etc. Should I be chasing the bolt holes or use a bottoming tap?

Just want to confirm I put this cable back together correctly. There is no documentation on this.. that goes into detail.

Does anyone know the dash numbers for the Boyesen extreme velocity intake manifold?

Do you run a gasket between the flame arrestor and the carb body?