Search results

Hello everyone, I need to ship a superjet from "Spring Hill, Florida" to "Buffalo, New York " it's sitting on a single jetski trailer right now. If i get it crated it's much easier to find a carrier that will do it for a reasonable fee, or even John is willing to help, but I rather do it...

Hello everybody! my 87 X2 is overheating, before i start taking things apart i just want to hear some opinions. everything was fine until this last ride in somewhat shallow water that was dirty and lots of weeds/debris that i had to clean intake grade couple times during that ride...

Hello, what would be the best way to clean dirty pistons, lets say i have the engine apart and pistons are looking good and reusable, i just want to make them look new again before assembly?? thanks guys!

Hello everybody! my 91 SN is overheating, before i start taking things apart i just want to hear some opinions. link to my build thread: http://www.x-h2o.com/threads/51812 everything was fine until this last ride in somewhat shallow water that was dirty and lots of weeds/debris that i had...

Hello guys, I recently put all my parts back together and getting ready for the water, but need some help on routing the water lines the right way! :ugh2: this is the only post i found related to my setup, but not much pictures there: http://www.x-h2o.com/threads/37528 thanks to all !!

where can i buy a set ? tried: http://www.xmetalworks.com but didnt find any there. thanks!!

Hello everyone! I'm about to prime and paint my 91 SN SJ, (hull for now) had tom's tubbies installed with 5200 and screws at first than glassed over with couple coats, took the screws out and 5200 the wholes. will post pictures: I would like to know the best way to sand all down to...

Hello guys! I got a roll of gasket (cork) material for my leak down test i do on my engines. now thinking about it, will I be able to make my own gaskets for real use? just paste and cut, unless someone had issues going this route ? thanks...

just as the title says. its a rubber piece, anyone knows ??

Hello guys! I need to purchase the following stuff to complete my project, please advice as to where this can be purchased for reasonable prices over the counter ? thank you... sheet of fiberglass (40" x 40") fiberglass resin 3M 5200 sealant 4lbs marine foam weldwood contact...

Hello guys! just got my 91 SN last week, bone stock and in perfect condition; both cylinders are 155PSI, fuel lines are not hard and fuel tank is not yellow! so far i just took stock turf off to install diamond grey hydroturf, and talking to a fellow member on here about buying his...