Search results

Just recently picked up a wetjet pipe for a good deal, and decided to try and fit it into my SJ. I read a few other threads on the subject then went to work. Had the section a couple wedges out of the chamber and rotate the outlet towards the front Gonna weld it up today and powdercoat it !

Ive been out of this for a while , but recently rode a modded SJ locally and I'm addicted again. Ive had this hybrid hull sitting in the corner of my garage for a while, and feel like I should get it out and finish it ! The hull is a s 300sx top deck, with a SJ bottom I just picked up...

91 Superjet, big bore 789 62t dual carb case freestyle ported 61x cylinder with custom sleeves and weiseco pistons done by northwest sleeve, 44 mikuni carbs, R&D intake with Boyesen carbon reeds ,ada girdled head 35cc and 38cc domes, Lightened flywheel 62T electronics, MSD,New coil, Factory...

I have a 789 with dual 44's, individual fuel lines to each carb with some small lawn mower fuel filters from autozone. Im having a problem, when I snap to full throttle it will bog until I let off and slowly accelerate then it will go to almost WOT but not quite? Ive been reading on here about...

Ive got a 90' superjet with a 62t engine I built over winter. I bought a stator and flywheel from a guy on here over winter, and a new gel battery. SO, when I charge the battery before I ride and ride for 2-3 hours then check the voltage on the battery its a little over 11 volts! Then if I dont...

I bought a set of domes from him, they got here fast and look great!!!

I was just finishing up installing new throttle shafts and butterflys, and went to turn the idle screw and SNAP!!! Now how do I set the idle?? Is there anyway to fix this. These are 46mm buckshots

I bought a pair of flame arrestors from him, shipped out super fast, thanks

I bought a set of buckshots from him, great communication , stand up guy! Thanks

Where do I get a new throttle shaft? I bought a set of carbs and the butterfly screws are stripped out in the shaft!! Anybody????

I just got a buch of stuff from him, everything looks great!! Thanks

I bought a factory chamber from him, He shipped it out fast. Thanks

Im getting ready to assemble my engine, and was wondering what to lube the crank seals with? I know on alot of automotive apps, that you use vasoline to pack the seal, so there is no dry start up? I already searched and didnt find anything out.

I just bought a set of 86mm wiseco pistons, and opened them to check em out and noticed each piston has a hole in the skirt on the intake side? It might be a stupid qustion but what are the holes for? My old pistons do not have any holes??

Im trying to put a blaster chamber in my square nose, but it seems too big to fit, I know I have to dent the chamber a bit, but the flange on the headpipe is actually touching the side of the ski?**** Post up some pics of the superjet with a blaster chamber**** I have searched already and the...