Search results

2000 RN superjet, How do you remove the bearings in the pump to replace them. I have the impeller off and nut off the shaft. So whats the next step? Thanks

I have a B pipe set up on my '00 RN with dual cooling through the exhaust manifold - water routed from the front of the head into the bottom of the head pipe and out the top of the head pipe - the water line goes straight to the pisser with a tee going through a restrictor into the stinger. I...

Last season I purchased a 780cc motor from CPT, the motor is awesome, but drinks more fuel than my 701cc. I used to get an hour and a half from a full tank, now I get just over an hour and I'm empty. We only ride in the ocean, and have to travel a good 20 minutes to find an open beach to mess...

Ok, I got a new Factory waterbox after finding the baffles in my stock one had broken loose and were rattling around in there. I have never replaced one on a RN and whatever position I put it in always seems wrong. The Factory waterbox pretty much is the same shape but no baffles. It has one...

OK, after trying to troubleshoot ongoing problems with my 2000 RN Superjet, I had to pull the motor after the crank let go,( it had a butt load of very hard hours on it, and I was only hoping to get through the summer with it) When I pulled the motor, I discovered a crack running down both...

I have a thread going now about the problems I'm having with my 2000 superjet. (need help or even an exorcist at this point) The ski works great on flat water and when strapped to a trailer, so I need a mechanic that can ride my ski in rough water and beat it till it starts to run like crap...

I have a 2000 RN Superjet that has been baffling me. The ski starts right up, idles smooth and runs perfect for about 20 minutes. It takes me about 10 minutes to cross the bay and go out Shark River inlet to get to the ocean, once in the surf I get about 5 to 10 minutes before it goes to crap...

I have been having an on going problem with my superjet, and have replaced about every part of the electrical system. (also exploring any other potential remedy, including a priest to perform an exorcism) I have a brand new stator, flywheel, start / stop switch. Tried- different coils...

On Sun May 22, 2011 - Four riders will leave Chincoteage Island Virginia and ski back to Shark River Inlet, N.J. Approx a thirteen hour journey covering four states and about 205 miles in one day. Two of us on superjets and two on waverunners. This event is being done to help Camp Happy...

I'm here sick of another N.J. winter, thinking about a road trip with a couple friends to Florida middle of February (obviously with skis). My plan is to hit a couple spots along the way and end up in MIami, where we will jet ski to Key West over the course of a couple days. We have done alot of...

Need some major motor work done, is anyone familiar with Jetmedics in Toms River?

I have a 96 Polaris slt 780, does anyone know if the 1050 motor will match up as a replacement?

I have an '00 RN with a B pipe and a few simple mods. The crank has locked up, when I move the driveshaft it only spins about an inch- then stops (It's not hydro lock) We are going to open it up tomorrow to find out what happened, but I have to assume its not good. Here comes the question- if...

This Saturday May 22, we are doing the charity jet ski run from Ocean City, Maryland back to Shark River Inlet, N.J. there will be a party held at the Headliner, Neptune, N.J. from 5:00pm till 9:00pm for anyone that would like to attend. Also anyone that would like to meet up with us along...

when riding in rough ocean conditions, what helmet do you use? I have motocross helmets, but won't the padding become saturated and annoying? Thanks

On saturday May 22, 2010 Myself and five other riders are going to jet ski (myself on 00' RN) from Ocean City, Maryland to Shark River Inlet N.J. The trip is approximately 170 miles. We are raising money for St. Judes Childrens Hospital and would appreciate any help thats offered. We are...

I want to say thank you to Rob from CP watercraft. He spent alot of time troubleshooting and repairing my RN superjet. (there were many problems !! ) He rebuilt my motor, not only quickly, but at a very reasonable price. This motor rips, and the ski performs better than ever. The motor has...

I need the hose that runs from the waterbox to the back of the ski, any ideas?

After a big hit, I broke my rear motor mounts. When the motor dropped back down it shredded the coupler (on the engine side). I replaced the couplers and put the motor back in. The motor runs fine on land, but the moment it hits water, the motor shuts down. As soon as the motor is under load...

After I destroyed the coupler on the engine side, I decided to cut the remains off with a grinder. It came off, but I put some nicks in the threads. Just enough to keep the new umi coupler from spinning on freely. The coupler threads on easily about 3/4 of the way before it stops at the...