Search results

What`s the best way to remove and replace a ring gear from an alloy flywheel. Heat the ring or freeze the hub ?

Any idea were these can be had? Looking to to learn the techniques used.

Where can i get a hold of the wider, taller bars that the surf boys are using on there blasters. Makes, prices...Cheers

My 760 is in and just hooking it all up, Wondered what you guy`s would do. 61X engine, Riva twin manifold & twin 44`s, Should i run a single line and tee off for a fuel feed to both carbs, Or give them a feed each and just tee of the return line. It`s spec is mild race,

Taking out the stock waterbox and replacing it with the above under the seat in my Blaster. The bit i`m unsure about is about the flow of water into it. There are a few cut out`s in it to spray water into the escaping gases. Now should it spray water with the flow of the exhaust or into...

Just got a clean setup for my boat. What i need to know is what position should the cut out be for the cables to pass through. I didn`t get any intructions with it, And i`m guessing it should go at 1 o`clock position. Does that sound right.

Does anybody know for sure if the bearings are a straight swap for yamaha one`s. Or better still any details of the maker`s so i can ask.

After the hood on my blaster falling and nearly taking a mates ear off i remembered there was a kit sold a while back that gave you 2 X gas struts to lift and hold the hood up. Can anybody remember who sold these or where you could get a set.

:Banane01: A big well done to Ant Burgess and the rest of the crew.:Banane01: Wish we could have been there to see it. Also a big well done to the ATP guy`s, It offical your motor`s ROCK !!!!:notworthy: Anybody know where we can see video of the freestyle event, We were all listening...

Reading the posts about this system i know what your going to say. But until i get some cash together i`m hoping you guys can help me out. Runs great and then nothing, Soldered & heatshrinked every joint, greased it all up, Can`t find any info on it and am trying to work out if it`s the...

What do you guy`s use for waterproofing the electrics. Just put on a jetinetics total loss and it seems to not like getting wet. Have you any tips for waterproofing the connections at the coil and in the loom. Has anybody tried to get an aftermarket system back in the original electric box.

What`s the correct way to loosen the driveshaft couplers on a superjet. I`ve heated them and still can`t get them to move. Thought i better ask before i get the big hammer out.