Search results

My SJ has been leaning a bit to the right for the last few years. I opened it up last weekend to find the foam is completely dry with no sign of any water or wet foam. What do you think?

Well I have told my son over and over never come out of the foot holds and I am the one that did. We were jumping some cruiser waves and doing some nose stabs when I over rotated and was going to bail. I waited to long to bail and I only got about a foot out of the tray and it slammed back into...

Any idea if these cases can be repaired? I took it to a local welding shop and they are don't want to try it. They said it is because fuel could be inside the crack and the weld will not take. It was smacked by the rod and is cracked. If they can be fixed any recommendations on who could do...

Here are a couple of videos of my SJ. It will rev fine on the trailer (1st video) but as soon as it goes in the water it will not rev past half throttle(2cd and 3rd video). At the beginning of the 3rd video it revs up higher after hitting the primer but dies down soon after. I have replaced...

I have a '97 Sj that is giving me some problems. It will start and rev clean and nice on the trailer. When you put it in the water it will not rev past 1/2 throttle and is very choppy. If you go in circles and get the exhaust out of the water it will pick up speed then completely shut off. I...

Here is the first ride on the BOB. It has a new 701 motor and just getting broke in.

I got a '94 61x with this carb top on it and I have never seen one. Does anyone know or have any info on it. It has DBP engraved on both sides. thanks,

I am trying to remove the steering thru-hull fitting on a SN at the pump. I got the outer plastic nut off, and the clip and the rubber plug/seal. How do you get the fitting off the ski? I tried to turn it a little but I don't want to break it, is there a trick?

My square was leaning to the right at a pretty good angle. At night I would notice a small amount of water would drip out from around the exhaust. I pulled the factory exhaust pipe out and noticed the seal around the flange was gone. I tried to use a hair dryer for a couple of days to dry out...

I am trying to buy a superjet in Cleveland and was wondering if anyone is heading south that could bring it along for some cash. I am in Lexington and do not have the time to go pick it up. bluegrassbulldogs@gmail.com thanks, Mike

I am trying to install a protec pipe on our Sj and I cannot find a simple solution to where the water lines go. Could you please look at the pictures and explain to me what goes where. thanks,

I have a stock 91 Superjet that I want a little faster. It has a o/p intake and ride plate. I want a little more top speed from it without affecting the dependablity. Where should I start?