Search results

hello iv slowly been building my xfs up over the past few months and last night got the engine and b pipe fitted, the engine is fitted all the way forward with extended coupler and the tank is a s**t to get in, as the rubber pipe from the water box is so low it causes massive issues getting the...

has anyone run two bilge pumps with a y in the two pipes then to just one thru hull fitting? would like to drill as little holes in my new xfs as possible and thought this would be a good way to help.

Got these carbs measure 46mm. What are they an how much are they worth? are they just 46mm Mikuni's?ThanksJim

Hello got myself a XFS that i plan to use in light surf, now the last thing i want to do is drill holes in my nice new hull unless im 100% certain its needed and my question is, all you people running xfs or xfr in the surf what do you use to secure your hood? as the hood is lower profile i...

i have a spare set of cases that have at some point in their live been full of salt water and corroded inside. the bearing parts are ok but the bottom is corroded as is a little but by where the seals fit. is there anything that can be done to repair these? i dont mind just putting to motor back...

Hi all i have had issues for some time with my ski taking on a bit to much water i used to have a atp pole bracket and the grommet wouldnt seal well so i know water went in through the hole in the bracket. i have now got a rrp bracket to run the dual breather tubing for my rrp pole to help...

iv got a rrp pole and breather bracket and wondered how people run the breather tubing inside the ski? do you have to run them between the tank and water box and round to the side? any info or pics would be great thanks Jim

i am looking at fitting a WB2/GP760 dry pipe into my 760 blaster1 (WB2 Engine). do these pipes give a good gain over the stock blaster 2 pipe? cheers Jim

i will be building a blaster up soon from bits off a blaster 2. i was wondering if the pump unit would fit and would i get any gain from this? i will be using the ski in the surf so looking for bottom end really cheers jim

What would cause my oring on the front cylinder of a ATP head blowing after 5/6 outings? The outer o ring for the water jacket looks fine but the two for the domes are totally crushed and one had broke. Are these supposed to crush or should you be able to remove the head and the orings be ok...

does anyone know what sort of compression i should get out of a 760 61x cylinder and a set of 35cc domes? cheers Jim

is it possible to run a umi pole with standard turn plate. iv got a new pole that my dad is swapping me his motor for but he wants to run the standard turn plate on it. is this possible?

As above really, read a few stories about skis sinking and wondered if the stock nose foam keeps the ski above the water? Jim:Banane09:

hi all im currently building up a boat for on the sea/in the surf al idealy want a set of sponsons fitted while its all apart. i know the tubbies from blowsion are good but what other makes are there as im in the uk and by the time iv paid import tax and postage from blowion it ends up costing...

as above really, i have got a set of 61x barrels ported and bored to 760 and a nice shiney new b pipe, do i need the manifold matched to the ports on my barrels? Cheers Jim