Search results

has anyone had issues with sbt head gaskets? specifically for 61x motors? ive put 2 down so far and they both have leaked water out of the side of the head within 5 minutes of riding. im 95% sure i am installing it properly, lap head and bock till flat. use new gasket, torque in two stages...

i recently installed a factory type 4 dry pipe on my x swapped sn, im running stock reeds. theyre in perfect condition, i checked before installing the pipe, just to make sure. will the stock reeds hold onto 7500+ rpm? or should i invest in aftermarket reeds. if i should invest, what do you...

i have a 1990 sn with a 61x single mikuni 44 sbn swapped in. im adding a factory dry pipe and rebuilding the carb and checking the reeds. while i have exhaust and intake apart, is there anything relatively cheap i can do to increase engine performance? ex polishing intake, removing the choke...

kept getting redirected to this loompasplace site when cruising on here, doesnt even take a click sometimes, happened about 8x this morning, and i cant back out, have to enter x-h2o.com back into the url bar, very annoying. anyone else have this issue? it started yesterday.

looking to buy a more performance oriented exhaust pipe/waterbox for my 61x swapped sn superjet as the stock exhaust has corroded through the water jacket and is pissing water onto my starter and the waterbox is leftover from the 650 that was in it. ive seen recommendations on b pipes and dry...

i recently bought a sn superjet that has a 61x swapped in, runs, starts fine, but i put a tach on it to help me tune the carb- it was running super rich and it only spins ~55-5600 rpm. my understanding is that these are supposed to spin 6250-6350 rpm. this has the stock 650 waterbox in it, would...