Search results

Hello all, finally time to start riding again this season as I’m prepping my ski to go out for the first run this year I am looking over it after the winter to make sure all is well and I notice a crack on the lower section of the hull on the side near the back. I have dremeled the crack to see...

Hello all, I have a 96 superjet all stock with stock bilge and a rule 500 electric bilge, took it out recently and it kept having to drain water every 15 seconds for a few seconds then stop and keep doing that over and over, so today I took it to the boat ramp to see what it was and I ran it in...

Found needed part.

Hello all I have a stock 96 superjet when I go to start it sometimes if it doesn’t start right away after a few seconds of cranking the positive wire from the ebox starts smoking and becomes hot, all my connections and grounds are clean and good and corrosion free, but my battery is starting to...

Hello all, I have a 1996 rn superjet. Just finally finishing up a defoam and refoam on it and glassing the tray back in tomorrow once the crappy weather is out of here... anyway just got it going again so I can get some time in before the end of the JetSki season by me and I converted the...

I have a stock 38mm carb from a 1992 Kawasaki js550sx. Carb needs a good cleaning and a rebuild, hasn’t been used for many years but throttle operates smooth. Comes as pictured. 45$ shipped thanks for looking.

Looking for a new pump nozzle for my 96 superjet, my current one has a crack near the mounting ears and need one so I can get this ski back up and going again. Thanks! Pic attached is what I need.

I have a 96 RN superjet and it currently has dual cooling but I’m switching back to single cooling as that’s how the PO had it plumbed but it’s unnecessary for my setup/water temps. Anyway i can’t find an answer about stock set up being backflushed it’s all dual cooling set ups or sj’s with a B...

Hello all, I plan on defoaming my 96 rn superjet this week/weekend coming up. I have ordered all the materials needed. While I’m in there I’m gonna seal everything up with some 5200 then reinforce the tray area and Install some drains, already have footholds. Anyway, I’m a little confused in...

Hi guys. Got my ski 2 seasons ago been riding it as is and it’s performing just fine I did some fine tuning of the carbs and small aesthetic stuff and added some pole bracket reinforcement and re wired the bilge all basic stuff so it works properly. Now I’m getting ready to get my hands dirty...

Hello all, I’m fairly new here to the forum, I’m in the middle of a big overhaul on a ski I picked up last season, took all turf off, about to do a defoam and just have a few questions I’d like answered regarding this stuff. So let me start out here and say I definitely need to defoam the ski...

Hi all I just recently purchased a 96 superjet. Ski is in okay condition cosmetically needs some touch ups and paint but not so worried about that right now. Just trying to get it all set up right. The motor is solo and clean with good compression for a stock motor. Anyway I’m slightly confused...

Hi guys, I'm new to the forum here and new to superjets this is my first one. I bought it used recently it's a 96 and it runs well, just was wondering if the cooling routing is correct? I'm just wondering why it's blocked off at the top of the pipe? Is there another place it goes in? And also...