Search results

2002 Yamaha Superjet $6,000 I have owned this ski for 8 years and have built it over that time. I love this ski but it's time to move on. - Jetmaniac ported and epoxied 735cc - Mototassinari VF3 Reeds - ADA Head 35cc Domes (pump gas) - Factory B pipe (Limited) (screws turn) - Dual cooling -...

Selling a Protec Ride Plate. At some point, someone added a scoop to it. It's alot like the Dominator. I can't find too much info on this plate. $80 buyer pays shipping. Located in CT for pickup.

This full electronic setup minus flywheel came out of a running XL760. $200 BPS, located in East Haddam CT

Hi all, here is my setup: Dual 46 Low Jet: 130 High Jet: 132.5 Low Screw: 1 out High Screw: 1.5 out Pop Off: 18psi -760 (84.75mm) with Mildly ported cases and Mild/Heavy Ported Cylinder -B-pipe Mod chamber -ADA head with 37cc domes, 170psi (raised ex port, less trapped volume) -Hooker 10/16...

I am curious if anyone has done any tests to see how much pressure is generated at the cooling line inlet. For example, if we took a cooling line end, capped it off, and put a gauge right there, what would the gauge read? Just out of curiosity. Thanks!

Anybody have ohm values for 64x CDI testing? I have a ski that wont shut off. I have tested everything I can think of accept the CDI.

Skat Swirl 12/17 144mm out of a used aquabot. The impeller has some damage so i replaced with a 9/15 hooker. I noticed almost no difference, but I’m keeping the hooker in. Asking $50 obo

Hi all, I used the idle drop method of tuning my low speed screws on my 735 (in an Aquabot). With the ski on the trailer, I turned the low speed screws in until I found the smoothest and highest idle. It ended up being 3/4 turns out. I hopped on the ski and it was falling flat on it's face when...

Hi all, I just bought an Aquabot. I've got a JetManiac 735 in there with MSD enhancer, B pipe, and 180psi domes. I noticed that 8 of the 12 vanes are pretty wacked. You can see one pretty clearly in this pic. Some are bent in the opposite direction. Will this cause significant loss in thust...

Hi all, I think I found a great way to adapt an aftermarket turn plate to the stock Superjet steering system. What you need: - (2) Bronze Flange Sleeve Bearings (16mm ID, 20mm OD, 20mm L), $3.00 at your local hardware store - M16 x 55mm Hex Head Screw, $1.30 at your local hardware store - M20...

Some of you may have heard the term Super Chicken. If you haven't, it is a nickname for Kawasaki's Sport Cruiser. Does anybody know how the term "Super Chicken" came to be? Here is the story I heard... One of the local race sanctions in New England held a class for the Sport Cruiser, which was...