Search results

I have an aquacarts beach blaster cart for sale - all in very good condition. Took it to Galveston a few times - complete salt away or salt terminator after every use. Sold my ski and do not have any use for this. I'm in the Houston area (77546) if you are able to pickup. This is the beach...

Selling my 2003 Yamaha Superjet. No time to ride given family obligations. I purchased the ski 2 years ago from the x, and it was advertised with 15 hours. I've added another 25 to that number. Ski was well taken care of -- plenty of salt terminator after all rides. Has normal amount of...

Triton wave trailer Manufacturer website: https://www.tritontrailers.com/watercraft/personal-watercraft/entry-level/ This is an all aluminum trailer for a single PWC or jetski. I purchased this trailer 2 years ago for my superjet - selling as I no longer have time to ride. This is the trailer...

Recently installed a new handlepole so I have the original one for sale. Orange sides are just plasti-dip and can be peeled off. Pole is in good condition - no cracks visible. For length, I put the end of the tape measure in the handlepole bolt hole and am showing measuring up to where the...

I was looking to swap out my stock pole to the thrust innovations handlepole I have. This is going on a 2003 RN SJ. It looks like I can use the factory bracket without any major issue. It does not look like I can use the pole spring, however. Do any of you run a thrust innovations pole with...

Doing my winter inspection and this year my steering cable has worn through and needs to be replaced. It's my first attempt at a steering cable replacement. i've got the handle pole off - and was planning to pull the cable out the back of the ski -- but, I cannot get to the through hull...

What do you use to make or where do you buy replacement coupling material that goes between the b-pipe and the exhaust manifold curly transition? mine has ripped under the hose clamps (likely from the vibration from the failed motor mounts in the other posts). Thanks! Anthony

All, Investigating excessive vibration from my SJ motor at idle, I've found that I have 2 failed motor mounts on the left side of the ski. I'm hoping to get help with a couple questions: In the pics below, I've stuck a screwdriver where the failure is. Basically, the rubber piece is bolted...