Search results

Looking for a single 38 or 40 Keihin for a 650SX.

Looking for a set of tubbies for a Tigercraft Aquabot or SV-1. Let me know what you got!!

Looking for a Tigercraft Aquabot V1 rideplate. Un cut would be ideal!! Or if anyone knows where the mold for this ended up .

Will fit Yamaha RN, SN, FX-1. These are a my own take on the old 24/7 internal fill adapter. The difference is it goes inside the fuel tank neck, and seals two o-rings. Much lower profile and no need for the ruber cupler. uses the OEM Yamaha RN and SN cap. Made from 6061-T6 Aluminium, Hard...

Anyone on here been able to get any product from Thrust over that past year and a half? Specifically there EZ start house, bilge and bypass fittings, trim? I know the industry is crazy right now. But...I've been trying to get my hands on a EZ start house for the past year and a half!!

2014 OG Aquabot. Purchased here on the X. Came with Stock 144 pump and ADJ foot holds.

Nice clean 95 SN chin pad with new HT cover. 175 shipped.

Clean fresh water SN water box. $150 shipped.

Need a RN water box. What's out there?

PJS ride plate! came off a 95 SN, so I believe it will fit 90-07 Superjet. Very nice condition, off a fresh water ski! $180 + shipping. Also have a clean fresh water SN water box $65 + shipping Please text me if serous 616-204-6752 PP or Venmo.

Hi guys. I'm putting together a 61x top end. I'm using a wiseco top end kit . My question is do I need to use shims on each side of the wrist pin bearing? My bearings are wiseco "B1031" 20x25x22.8 They seem to have excessive side to side play when installed on the rod. I purchased the top end...

Hi guys. I'm looking for someone in West Michigan that does Cylinder porting. I have a fresh set of 61x cylinders I'd like to get a mild port job done on. Any suggestions would be great.

Ok guys I've done some looking and can't fine any info on this. I just got done reassembling my 61x 701, all new oem gasket and crank seals. Long story short I had to split the case after les than a tank of gas.... Here's my question. Is it safe to reuse my crank seals or do I need to...

I've got a 1994 FX-1. It has a GroupK 650- 701 big bore kit on it. So it useing a 6m6 case, 6m6 cylinders opened up to 81mm. And a oem Yamaha crank. I had a air leak on my cylinder base gasket so I pulled the motor to disassemble and inspect the rest of it. It all looked good except for my rear...