Search results

Anyone at Daytona want to take a break from surf we made a nice Mtn bike trail at Riverbend Nature Park on Airport Rd right here in Ormond Beach. FYI!

Almost ready for bonding, been working on this Tom 21 hull for a year now, had to set and realign mid shaft assembly and move pump mounts back to use a SJ driveshaft. These things came raw, but light! Added carbon in all know FX1 weak areas, under pivot, hood latch areas, bottom, and after...

What steering plate and cable clamp set up are the cool guys using with a stock pole? Doing a ground-up “Tom 21” build, using a Cold Fusion on my “daily rider” but inquiring if there’s a better setup then bolting an aftermarket cable clamp on. Thanks

Worx 144-148 Yamaha pump shoe $140 new Factory mod chamber $300 good cond. FX1 midshaft and o rings $100 new Available in Daytona, may ship?

Building possibly the last remaining Tom 21 FX1 and wondering how far does stock driveshaft protrude past firewall? This one is around 102mm. Also FX1 mid shaft length? The one I have is about 130mm

Got this “Tom 21” hull from a good friend, turned out to be a lot more than just assembling a ski! Hull is super light but a little thin so reinforced nose top and bottom, had the luxury of really reinforcing the pole mount area properly, bottom and sides of bottom, and hood mount areas. Had to...

Need to install/fabricate breather tubes on a new Tom21 build hood, any suggestions? Fabricate, find similar, rob from donor FX1? Area from hood liner to hood is smaller than stock. Thought thin pvc but heat may affect that. Make some carbon tubes? Ouch!

Building a Tom21 FX1 wondering is there any disadvantages to shortening the stainless exhaust tube for the engine compartment side to compensate for 6” shorter hull? Would like to keep stock flange on exterior for better seal if possible.

Looking for a new or newer SJ as a donor for new project but can’t find one here in Florida, anyone know where to find a leftover 2020/2019 or squeaky clean used one?

Hoping to find an FX1 fuel filler hose or ideas on an equal substitute. Also hoping for a good front bumper, neither of these come up as available on any of the Yamaha parts sites.

Just finished 144 pump cut and weld conversion but just used a stainless prop that came with the pump I bought (I think its a stock blaster prop?). Any tried and proven recommendations for a thrusty (is that a word?) surf only impeller for a 144 ? Don't care about top end at all, have a new...

Did the cut and weld 144 pump but not sure what cable and nozzle options are working successfully. Tried the stock cable but it wont turn equally right and left. Used the stock FX nozzle and made cutouts so it would turn far enough, but have another shorter stock SJ nozzle if that will perform...