Search results

Got a WB2 that I dropped a yamaha 1100 motor in. Left it last weekend and it was running fine. Go to start it yesterday and the fuel pump is not pumping fuel. I replaced the remote pump when I did the conversion last year. If I pour gas down the carbs it starts right up. So I checked the...

I can't seem to find info on wb1 hull reinforcement. I know I need to reinforce the transom but do I also need to reinforce the sides of the hull like a superjet? My blaster will be surf ridden. Anyone have any pics of their reinforcement?

Does anyone know of a good write up for dropping a Yamaha 1100 motor in the Wave Blaster 2? I searched and can't find what is involved with the exhaust routing and modifications needed to make that work. I got the motor mounting down I think. Planning on using the RAD Dudes blaster conversion...

I have a 750 Big pin engine and an ADA head. The domes that came with it are KA8028 and KA6528. Can I use these with my 750 and if so, do you know what compression each should give? I am only asking because it looks like these domes are for an 800 and a 650 engine. Thanks

Searched and didnt find anything that matches my issue with the pisser. My Superjet is completely stock. When idling or low throttle, the water out of the pisser is a steady stream. When at half to full throttle, the pisser stream appears very restricted or mostly air. It is obviously at...

I am a bit stumped. I have a stock 07 Superjet that has been running well all spring and summer. Took it out on a couple mile run to the local sand bar and it ran great all the way there. Stopped for a while and rode around occasionally once I got there. It was running great and all of a...

Searched and did not find anything answering what is happening with my 2002 SXI Pro. I just rebuilt my carbs using the genuine Mikuni kits. My pop off is 34 psi in both carbs. I started with my low speed screw set at 1/2 turn out and high speed at 1 turn out as per the service manual. Ski...

Had some bad luck with my 02 SXI this weekend. Something chipped/broke off in the engine and destroyed the rear piston and head while riding. The crazy part is it ran long enough to get back to shore. See pictures: My question is what do you think my next step should be. I am obviously...

Hi everyone, new member and new to stand up jetskis. Bought the jetski in the title and it is a blast to ride but I have a noise that I can't find an answer to with searching. When the ski is on the hose and at idle, it sounds like something is vibrating or a metallic rattling sound but goes...