Search results

looking for both pieces of the front hood hinge for Kawasaki X2. Dave 8055503355 thanks

The dates have been set for March 13-15, 2015. Hope to see you there!

Great riding! Nice work Brandon Lawlor, Zack Bright, Pierre Maxient, and all other riders.

Here is how I did my hand warmers. Take a water line of your choosing and route it up to the handle bars, then, Drill and tap a hole in the center of the bars and attach a threaded 90 degree brass fitting. Drill a hole or two through the grip. Add a little sillicon to the bar end cap...

Who's gonna make it out? Looking forward to seeing and riding with some of yalll!

Please help, any advise or suggestions welcome. Im in the middle of sanding a few minor bulges out of my pump wear ring. I have tried several things, Dremmel grinding stone, glued sand paper to round closet pole and put that on the end of a drill. This seams to work best so far.... want to...

Put me in one of these, fill er up with gas, zip tie the throttle, and let me go for one last run!

I was researching around on the internet, and I read somewhere that the old wear ring could be cut and then pulled out. Then either a yami or seadoo wear ing can be placed into the stock housing. If anybody know more about this, please explain. Where to buy, any how to tips. Thanks

My buddy gave me a complete stock SN hull, missing a carb, but had an ac racing handle pole and a top loader. Motor was frozen, so I decided to tear it down. I first rockered the nose, and cut 3 1/2 off the back of the ski. I shaped and made tubbies. Put a front foothold in through the...

Last christmas I bought a couple skis for $500 a piece, people need money bad now and couches are a dime a dozzen. The yellow ski need some minor electrical work, and the black ski I painted and turfed, for practice. I got them all cherried and sold them in the heat of summer for $2500. Cash...

What is the best way to keep water out of your eyes riding in the surf? I plan to by a helmet soon and was wondering if there are any goggles or facesheilds that you can see out of but will still keep water out of the eyes?

:439: So after blowing my engine, I found this site looking for some new mods. I came across Austin's Winter X2 build. So I got up from my computer and went to the garage to begin a 8 month project. I cut 3" off the rear of the ski. Moved the steering back 5 + inches. And made...

I just put back together my motor, and it ran good for the first hour and no cavitation, The next time out it started cavitating on me. It does it almost all of the time at both high and low rpms, I did get it to go again for a little bit, I tried to silicon the pump better, no luck. My...

I want to know if I should cut 3" or so off the back? What is the best way? Any good threads to look at? What is going to be best to fill the tray back up with? Ping pong balls and foam? What type of foam is going best and not cost too much. Should I convert it into a flat deck or just put...

I have a couple stock coils. One has 4 wires including a blue wire, but my coil on the ski only has 3, no blue one. I am trying to put in a a dales bad attitude coil that also has a blue wire. Does anyone know how to wire this coil for my ski? Thanks

Has anyone put a trim lever on a X2? Where can I get a system for an x2 or a superjet? How can I make my own?

I just bought some dual carbs for my 650 x2 and wanted to know if they will be worth the trouble. I also bought reed boosters and wanted to know how these will affect me?