Search results

I have a 94 Blaster B1 that I have rebuilt and have been having problems tuning it for bottom end performance. It runs very good on the top end and idles very well. It bogs then cleans up as it gets to full throttle when I punch from low speed or when I am at high speed then slow down for a...

At the begining of last season, I put a solas mag pump and a hooker prop in my wb1. I put in new bearings and seals as well. Toward the end of the season I put in a smaller pump cone and when I took the old one out I noticed the grease inside the pump was watery and discolered. I left it for...

I am trying to minimize water getting into my engine bay because I keep getting water in my carb. So far, I put the oem flame arrestor back on, have a coupler cover on, and just bought some versiplugs. But, I am wondering if anyone has tried putting frogzskins over the tops of the black rubber...

I have been having problems keeping water from getting into my carb if i dive the nose under water a bit. I feel like i have tried everything. I put the oem flame arrestor back on, which seemed to do better than the tau ceti i had before, but still got some water in it the other day. I tried...

I have a 93 WB1 that I rebuilt over last winter and have now been riding this summer. I am getting much better on it and have been riding some surf and doing flat water stuff. Lately when I dive it under, it ends up running a little rough for a bit until it eventually clears out. I figure...

I have been reading and researching intake grates and ride plates for a little while now and still cant decide on what is best for me. I ride a little of everything, lakes, ocean, rivers, surf, etc. I have been setting up my B1 to be an all around recreational type ski. I have seen a lot of...

I'm nearing the end of my B1 build and am looking at carb options. I was planning on a single 44 and am wondering how much performance gain I would get if I went with a dual card setup. I know the 62T cases were designed for the dual carbs and the 61x for single, but would it be worth it to...

I just finished up rebuilding my pump with a new Solas mag. I put the pump in, and with a little manipulation, got it aligned. Then the midshaft slid right in and both pins were perfectly aligned. Now I am dropping the motor in and notice the 4 mounting bolts have a much smaller diameter than...

I am rebuilding my pump and I just got a solas mag pump. I am wondering what the noticeable differences are in having a bored out nozzle compared to stock. It seems to me that most people are getting the bored out nozzles for low end freestyle riding. I have been setting the ski up for good...

I have been reading up on the hooker props and am looking to order one from jet maniac soon, but cant decide which pitch is best for me. I have been rebuilding my ski and am trying to set it up for a good all around ski. I ride lakes, rivers and streams, and will also ride surf. I am looking...

I have been rebuilding a 1994 waveblaster. I pulled the motor the other day and stripped it all down. The flywheel was all rusted out on the inside and the stator was in rough shape. I want to get a new flywheel and was wondering if there are any after market ones out there. I havent been...

Hi everyone, I just joined and have been getting aton of good info here. I just bought a 94 waveblaster that is pretty muchall stock. It starts right up and runs strong, but is missingsome things and I am not sure what is what. I know the oil tank andpump is removed, so I just have to mix...