Search results

$150 shipped

Is there any aftermarket or modification for the oem flat tops to make them like the style pictured? I browsed around mcmaster-carr a bit but didn't see anything. TIA

right side is cut, widened and turfed left side is completely untouched with brackets, no hardware $140 shipped sold

Didn't end up using it. Complete kit with lever and cable included $700 shipped

This is the newer one piece version. $150 shipped

Quite rare. These allow you to use oem style air box on aftermarket carbs. No plastic airbox included $200 shipped

Driveshaft show great splines Solas 13/17 Stubby cone, oem 144 pump New thrust ez-flow pro trim with cable and lever Complete setup $1200

Ported cylinder AND cases. Epoxied 718 only a few months on it. New ADR crank. ADA head 35cc domes. Comes complete with JSS stator, flywheel, bendix and flywheel cover. $1200 SOLD

$240 shipped 61x stator is completely redone by JSS

$90 shipped no backing plates but can use virtually plate or just bolts

$sold shipped

Ported cylinder and cases. Epoxied 718 only a few months on it. New ADR crank. Comes complete with JSS stator, flywheel, bendix and flywheel cover. (no manifold)$1100 OEM pump with solas concord 13/16 plus drive shaft $350

Seen better days but solid as a rock. This was Chris Grace's hull, he had it for a few months then I've had it for a few years. $2700

Need one. thanks ya'll

Would someone be able to fab up a bracket for me? Can give exact specs/angles Thanks

Uses the superior kawi pump setup whilst boasting 'adapters' to support any engine type (kawi, yami, octane). The adapters are simply chunks of aluminum to make your own motor mount locations. Somewhat smaller hood opening makes installing/removing items a bit of a pain, however if done in the...

Cheap hull for those wanting to break into the AM boats. Very tight fitting the internals with the small hood opening. Insanely wide tray, tends to sink when idling around. Once at a moderate speed, the ski become flat with masses of water splashing into the air as the it just plows; also giving...

Help!!!! :mad: Accidentally drilled too deep while tapping the manifold. Is this area below where water flows or exhaust?? Will just putting the bolt in be fine?

What is this from? I searched but could no find anything. It does it on one of our skis but not the other.

Luckily wasn't in a deep lake and got a quick rescue but the q8 went down. Didn't know why it went down so fast because it never takes on water. Upon dragging it up land we discovers this torn epic scupper flapper. Piece of poop junk