Search results

Is there a difference in ignition coils on sj's? Mine is broke on my 760 and I was hoping I could take the one out of my 650 and put it in?

So, I have been trying and trying to get my ski dialed in! Last year my bendix exploded while out one day. It took about 3 weeks for me to get to it and get it fixed. I got it fixed and had much less power than normal. I did a compression test (thinking that I couldnt run the motor after it took...

So I read up and found that the SN steering cable will work on a RN but is 1" shorter with less throw. Anyone experience this? Is it a big difference in the water or should I wait and find a RN steering cable? I dont want to change it twice!

Anyone ever had their ski not be able to turn one way? I was out riding last week and my ski would not do a left turn. If it did at all it was a very very wide left turn. I pulled it up on the dock and the nozzle was turning and everything looked fine. Went back in the water and it did it again...

How can I tell the difference between a 61x flywheel/stator and a 62t flywheel/stator?

I was out riding one afternoon when my ski seemed to lose a lot of power. The exhaust sounded deeper and it had weak throttle response. I took it to shore and checked over the motor to see if I could tell if there was something obvious and after a couple starts it wouldnt start anymore, I would...

I have a built 760 motor that I bought a few months ago. I was out riding yesterday and it seemed like either my start/stop switch was going out or my battery was going dead. But I just charged the battery the night before cuz it hasnt been ran in a few weeks. Anyways, i could get the ski...

I just got through rebuilding my ski and bought some Trinity Composites Footholds and they are like heaven to me! They were easy to install and fit right in my RN SJ. They also have alot of room for my size 12 foot. I highly reccomend you check these footholds out if your thinking about...

I've put so much time in rebuilding my 2 skis that my girlfriend is upset and wont put out! :spankme:

I am removing the Pro-Tec drop nozzle from my old wrecked ski and putting it in my new one that im rebuilding. I bought my old ski and got one ride on it before i wrecked it (don't ask!). When I bought it the drop nozzle was without a spring and was put on the right way dropping down. I want to...

I have two SJ's that I am returfing tomorrow. I just put footholds in them and have some 5mm undermat and two sheets Hydroturf and some contact cement to apply them. I was going to cut a pattern out of craft paper then cut the hydroturf, grab the heat gun, and glue them on. Anyone have any...

I am putting my trim system in from my last ski and am putting it in reverse for more lift out of the water. Running the cable, do you think it would be alroght to go through the stock bilge hole through the back?

I am attaching a couple pics of my tray. I took all the turf off getting it ready for footholds and found a big hump going across it about 3/4 back from the front. I pushed down on it and could here air escape out the inside hull. I cut a little hole out to look underneath for water or what ever...