Search results

Still new to yamahas. But will a 701 cylinder fit on a 760 bottom end?

I just crossed over to superjet side. I picked up a sn superjet with a 650 Runs good. But just found a waveraider with a 760. Is the 760 a decent motor to put in and are the waveraider rubber motor mounts the same (superjets are bad ) Just thinking about putting this thing together. And if I do...

Anyone with 46s on a sxr?

Anyone running 46s on a SXR? Looking for some jet specs. :fingersx:

What should the squish on the sxr800 with some mods? Changing the head and would like to check it.

Has anyone had to repair or replace the pump shoe on a SXR800. Mine looks a little beat-up.

See if knows whos carb they had on it and what was done to the engine.:Banane13: Thanks again!

Thanks, Any help would be great.

Is anyone running a single 48mm on a sxr800 with a wetpipe? How did it run? Im looking for pop-off and jetting specs

I ll give a call. Im running a 28cc domes now and my compression is 190 Do I need to change dome size when I order new dropped domes or will the compression stay the same. Im running pump gas 92-93 and a wet pipe. What the differance if I put a 040 or 060 as far as perforrnance? Hows it gonna...

I was thinking getting a thicker base gasket( .040 to .060 ) and droped ada domes. Anyone running this?

base gasket Flat and surf riding

Thinking about putting a thicker base gasket and drop domes in my sxr. Is it worth doing?

Just picked up a sn superjet with some good mods. Its a 650 with a group k big bore kit ,single carb ,riva pipe. But it seems to bog when coming out of a left turn and then going straight. When I got it the tank was dry. The ski was stored for a number of years. Any ideas? Thanks

That X-2 looks good! Nice job, I started building my X-2 and wanted to know what did you do with the trim. Is the nozzle straight or is set up or down? Can you post any pics? I was thinking of running a sx nozzle will I need a wedge? I got alot of ski but new to the X-2 so I try to find the best...

Thanks, Does anyone have pics of cutting there hood flat and what to do with the trim knob? I would like to get rid of trim knob and fuel switch and smooth the top out. But like to put a trim lever on the bars. Just not sure how to hook it up inside the hull. Anyone with some trick ideas on it?

Starting X-2 750 project Looking for the best mods to do that work. Also, What can be done with the trim control? Can I move it to smooth the dash panel. I would like to cut the hood and fill the gas door in too. If you got any good mods and pics throw them on. Im looking for good ideas that...

What dome size is that? thanks

Whats the most compression I can run with pump gas on a 93 sx 750? And what dome size would that be? Thanks

I do have a exta hull I can take the left bracket out and use it to clear the carbs. Will the twin carbs work or is a signal carb better?