Search results

looking for one 46mm Blackjack carb, I have 2 wanting to put them on my triple motor! Thanks

Just installed my zeeltronics on my sxr 800 (actually it's a 920 dasa) and it has the wax programming in it, it starts right up but will not rev out and I have raised the rev limiter way up but it still only goes half throttle and boggs. Check it on a laptop and it seems to be doubling the...

Looking to buy a Zeeltronic ignition for my kawasaki 800 motor with dasa topend, does anybody on the site sell these? Thanks Tony

Cant get anybody to respond and Kyle will not answer nothing Took over a month too get pistons and trying to get it bored, what clearances on the piston is the best to run on a Dasa cyl 89.5mm Thanks for any response!

Has anybody tried these starters and have any opinion on if they are stronger and have more torque than the stock starter? They sound like they are built well and who sells these on the forum, I think they sell them through Hot Products too. Let me know. I need the #S1092 mht Kawasaki 800

Went to see Travis Pastranna new movie last night and highly recommend it I think it was the best one yet and being 3d was better than I thought! What was sad was everytime Travis had a crash the first words everybody said was is he (knock) out again!! 2 Thumbs up.

Has anybody else had the front seal pushed out by the crank bearing with a Hotrods crank. I have put it together twice and after 2 weekends of riding it pushes out the seal and the cases are not worn or damaged the only thing I have found was the crank bearing going on the shaft I could force...

For us guys that don't have extra cash for a Mag setback pump, I decided to make my own setback pump. I bought a trashed out pump on ebay for $50. and cut a 1 3/4 off the front of it and then welded it to the front of my pump and cut the ears off and welded them to my pump, and then cut off all...

I am looking to put in a stroker crank in with my bigbore topend. who is running them and what stroke is the hot setup for the sxr. Are you running cyl. spacer or cut domes? I am looking at a 3mm crank and just need some feed back. Thanks for any advise.

Well I totally understand why you guys with A/M hulls get so excited about them! I bought this hull from Tom (superramjet) and finished the build he started, not with a 1200 motor, but I used all of my Kawy parts from my 750 pro. I had to do a lot of changing mounts and brackets since he was...