Recent content by Xodiac

Take both and ill throw in the aluminum trailer Description of ski with Gen 2 Nose: 701cc Miller ported motor, Riva pipe, hi comp head 185 each jug, custom waterbox, custom exhaust outlet, skat 9/17, scoop intake grate, reinforced one piece hood, UMI steering and bars, Blowsion seat...

Thanks guys i actually measured it and found an exact gasket on the site used in the linked post. In case anyone else runs into this problem, i found the gasket at http://www.mcmaster.com/mv1459975500/#9464K114

hey bud im looking for 2 gaskets for a Hi Comp Protec Head on a yamaha 760 unfortunatly i have no idea what the dimensions are.

hey all i have a Hi Comp Protec Head on my blaster 760 (64x) I can seem to rind a replacement o ring for the domes. does anyone know where i can find these or a similar replacement??? Thanks guys

@2thelake good! i'm glad my post could help you get your running again!

2thelake: i did all of this because my solenoid wasnt not clicking. The way a solenoid works is that when power is applied it clicks into place and completes the chain in the two big red wires on top. If it does not click it is either not getting power, not grounded, or is not working. my...

I have a water proof back pack that i keep items like rope, jumper cables, area maps, fire extinguisher, 2 pelican cases first case: screw drivers wrench pliers ext. second holding extra spark plugs phone license fuel filters and extra parts. I through my helmet in the back strap it on and head...

ok guys i fixed the problem and im going to explain my process of elimination so that everyone that reads this will understand and hopefully find my method helpful. First: i tested the battery and found it was working properly and that my fuse was also working (replaced fuse anyways for good...

ok guys i fixed the problem and im going to explain my process of elimination so that everyone that reads this will understand and hopefully find my method helpful. First: i tested the battery and found it was working properly and that my fuse was also working (replaced fuse anyways for good...

so heres waht ive gathered. i hooked the solenoid up, pulled the brown wire and connected it straight to the battery. nothing. this means it must be on the ground. tested wires back to the ebox where all the ground are conneccted. im assuming the ground wire going to the stator if fried. im...

update. with the continuity tester: solenoid is working. Starter is working. fuse is fine. battery is good. start switch is good. killswitch seems to not have a circuit but when jumped from the ebox still will not fire. i am going to spend my saturday testing every single wire in the hull. any...

update. with the continuity tester: solenoid is working. Starter is working. fuse is fine. battery is good. start switch is good. killswitch seems to not have a circuit but when jumped from the ebox still will not fire. i am going to spend my saturday testing every single wire in the hull. any...

bump

bumb

battery is good even used an extra battery i have. the fuse is fine. also pretty confidant in my grounds but i will recheck tomorrow.