Recent content by wayne

yes there will be a couple of us camping that night if it is not flooded. texoma up over 17 feet as of today.

contact the District Attorney from where he is and file theft charges on him.

boyd plus dogs

me plus my wife

in pic fourth pic you can see where the weld is barely tacked. I just don't want any one to buy one and they get hurt due to the welds breaking. I don't barrel roll or back flip. mine broke just jumping waves. with these welds they are not made for hard riders.

I kept the pole because I had to have one and I passed up on several others. I had to have my build ready and after waiting several months you offered a refund after you sent the pole. you never offered a refund until I posted the neg thread on you. you are the one that said it was lost in...

here are the pics

new update three months of riding and my pole is broke. after removing to get repaired I noticed all the welds are barely holding. you can see between the pieces and can tell they barely got tacked on one side. I am lucky it only broke in one place and not multiple places. I will be posting...

1 large gray shirt 1 large gray hoodie what is the cost?

The routing is not the issue the length of inner cable is too long

I have a round nose hull with an aftermarket -3 handle pole. I have a square nose cable and it is about three inches too long (wish I had that problem lol). what cable do I need to run with this setup? Any advise would help. thanks, wayne

will a square nose steering cable work on a round nose hull?

still have not received the chin pad and breather tube. was mailed nine days ago so i was told.

just got all the sanding done to start my install. this will help me a lot for the great pics. wayne

if you ever have to change crank seals during the season. don't tear your engine down just flip it upside down and pull the bed plates and bottom case, lift crank, change seals, and realign the bearings. put yamaha bond between the cases and retork. quick and easy.